Summarize the test procedures for the dry heat shrinkage of polyester staple fiber
The test steps for the dry heat shrinkage of polyester staple fiber: 1. According to the requirements of the instrument manual, make preparations before the test, and make the heating tank reach the specified temperature. 2. Prepare the sample as specified in Chapter 7. 3. From the sample that has been adjusted and balanced, randomly select 20 fibers into 1 bundle, take 2 bundles in total, and arrange them separately to make one end neat. During the finishing process, the fibers shall not be stretched by accidental tension. 4. Clamp a bundle of finished fibers into the holder, and hang down the specified pre-tension clamp. Hang the tension clamp on the small hook of the holder, and insert the holder into the sliding groove. 5. Turn on the measurement switch, move the holder to make the fiber bundle at the position of the light hole, gently put down the tension clamp on the small hook with tweezers, adjust the reading handwheel, as long as its length is between 19.5 and 20 mm. If the deviation is large, the position of the tension clamp can be adjusted appropriately so that when the marking line on the projection screen is tangent to the flat opening of the tension clamp, write down the value Lo (^ to 0.01 mm) on the reading handwheel, remove the load, and change The tension clamp is hung on the small hook again, and the Lo (^ to 0.01 mm) of the second beam is measured by moving the clamp. 6. Raise the heating tank so that all the holders are placed in the heating tank, close the cover, turn on the heating switch, and record the time when the temperature of the heating tank rises to 180℃. When 30 minutes, turn off the heating switch and open the cover After the heater is cooled to room temperature, press 7. Operation to measure the L1 (^ to 0.01 mm) of the two bundles of fibers.
This is an internationally recognized standard which acts as a form of guarantee that everything GESTER International Co.,Limited does is managed to the highest quality standards.
To build customers value by delivering high-quality products, services and solutions in innovative and cost effective ways. GESTER International Co.,Limited will realize this mission by setting the highest standards in service, reliability, safety and cost containment in our industry.
The best way to determine the ideal strategy of textile testing equipment is to continually test and refine your selling and marketing tactics.
1. ISO 5402-1: Specifies the flexometer method for testing leather flex resistance under repeated bending.
2. ISO 17694: Defines test methods for footwear upper and lining flex resistance, simulating real-world bending stress to assess long-term durability.
C
Quick links
Products