Gester Instruments | Professional Textile Testing Equipment Manufacturers Since 1997
Summarize the test steps of polyester staple fiber dry heat shrinkage
The test steps for the dry heat shrinkage of polyester staple fiber:
1. According to the requirements of the instrument manual, make preparations before the test, and make the heating tank reach the specified temperature.
2. Prepare the sample as specified in Chapter 7.
3. From the sample that has been adjusted and balanced, randomly select 20 fibers into 1 bundle, take 2 bundles in total, and arrange them separately to make one end neat. During the finishing process, the fibers shall not be stretched by accidental tension.
4. Clamp a bundle of finished fibers into the holder, and hang down the specified pre-tension clamp. Hang the tension clamp on the small hook of the holder, and insert the holder into the sliding groove.
5. Turn on the measurement switch, move the holder to make the fiber bundle at the position of the light hole, gently put down the tension clamp on the small hook with tweezers, adjust the reading handwheel, as long as its length is between 19.5 and 20 mm. If the deviation is large, the position of the tension clamp can be adjusted appropriately so that when the marking line on the projection screen is tangent to the flat opening of the tension clamp, write down the value Lo (^ to 0.01 mm) on the reading handwheel, remove the load, and change The tension clamp is hung on the small hook again, and the Lo (^ to 0.01 mm) of the second beam is measured by moving the clamp.
6. Raise the heating tank so that all the holders are placed in the heating tank, close the cover, turn on the heating switch, and record the time when the temperature of the heating tank rises to 180℃. When 30 minutes, turn off the heating switch and open the cover After the heater is cooled to room temperature, press
7. Operation to measure the L1 (^ to 0.01 mm) of the two bundles of fibers.
In addition, there are other test instruments: Wascator Automatic Shrinkage Tester For Fabric GT-D34
Application
Wascator Automatic Shrinkage Tester accelerated washing apparatus for knitted and woven fabrics to assess shrinkage in accordance with international test methods. Also used for assessing fabric stability, color fastness, finish durability, spirality and pilling to washing.
Feature
1. Automatic Wascator Shrinkage Tester MCU program controller, build-in ten sets of washing program that ISO required, and operator program capability.
2. No need to fix to ground with foot screw, operating stably;
Soft link between rotating cage and rack, low vibration and noise;
Variable frequency motor, switch smoothly between high speed and low speed, low temperature increment of motor.
3. Blue fluorescence LCD display, test state dynamic icon shows, easier to catch the eye and operation convenience.
4. Non-touch capacitance water level meter to measure water level accuracy and reliable
GESTER International Co.,Limited is fully committed to supplying high quality products and services.
You can count on GESTER International Co.,Limited to be your one stop shopping site for most of the quality products you are searching for. We strive to offer a wide variety of products for you to learn about and to purchase.
Time is one of the biggest challenges cited by manufacturing textile testing equipment.
Quick links