How to maintain the display of the instrument
With the advancement of technology, display screens are used more and more widely in instruments and equipment. For instruments and equipment, the display screen can not only visually observe the progress of the test, but also control the progress of the test at any time and so on. So how to maintain the instrument display screen? Maintenance method: 1. Antimagnetic: long-term exposure to a magnetic field may cause some electronic components to become magnetized or damaged. 2. Anti-high temperature: High temperature will greatly shorten the life span, and the electronic components will also accelerate the aging. It is best to place it in a well-ventilated place. 3. Moisture-proof: Humidity has a great impact on life. The environmental humidity should be kept between 30%-80%. When the humidity exceeds 80%, condensation will occur, and the electronic components inside the machine may be damp. Rust, corrosion, or severe cases will short-circuit the circuit board. The key mask will also degummed. When the humidity is lower than 30%, electrostatic interference will occur. Therefore, if it is not used for a long time, it is necessary to regularly power on and work for a period of time to drive away the moisture in the machine. 4. Anti-glare: Under the irradiation of strong light, the body is easy to age and turn yellow, the LCD accelerates aging, and reduces the luminous efficiency. As a result, the brightness has to be adjusted to a high level during use. As a result, the aging is further accelerated and the life of the display is greatly increased. shorten. Therefore, do not place it in a place with strong sunlight or where light must pass. It is best to place the monitor in a place where sunlight is weak or without light; 5. Dustproof: The printed circuit board inside the monitor will attract a lot Dust affects the heat dissipation of electronic components. If the temperature is too high, it will cause leakage and burn out the components, and the dust can also absorb moisture and corrode the electronic circuits inside the display. Therefore, the monitor should be placed in a clean and clean environment during normal use. 6. u200bu200bOthers: When adjusting the brightness knob, it should be slow and steady, not hard and hard to prevent damage to the knob. If the display content does not change for a long time, it is best to use a screen saver.
If you are looking to get started with textile testing equipment, it's important to find a quified . Let GESTER International Co.,Limited be your provider. Visit us at GESTER Instruments.
If you are looking for an excellent service in the UK then you can go to GESTER International Co.,Limited. They have almost everything what you might require for your tensile tester manufacturers.
GESTER provides a number of tensile tester manufacturers designed to handle tensile tester manufacturers.
Ball Burst Method (ASTM D3787): Steel ball penetration for textiles/films using testers like GT-C02-2.
Hydraulic Method (ISO 13938.1): Fluid pressure on rubber diaphragm for industrial fabrics via GT-C12A.
Pneumatic Method (ISO 13938.2): Compressed air for breathable materials tested with GT-C12B.
Results are influenced by raw materials, yarn properties,
Quick links
Products